Commercial Mold
Keep your building operational while licensed mold cleanup work proceeds, with a written scope before anything starts.
What Goes Wrong
The most common failure is treating the surface without correcting the moisture source, here is what that looks like and how to avoid it.
Wiping or painting over visible mold leaves the moisture source active, so growth returns within weeks in the same area.
Moisture mapping defines the full affected area before any scope is written, so the source is identified and corrected, not just the visible growth.
Louisiana R.S. 37:2181 to 37:2192 requires a licensed mold cleanup contractor, work done by a general crew carries no legal standing and can void documentation.
Every partner arranged through us holds the Louisiana mold cleanup contractor license, so your post-job documentation holds up to scrutiny.
Removing mold without containment barriers and air scrubbers spreads spores through HVAC ducts and into unaffected areas of the building.
Containment barriers and negative-air scrubbers isolate the work zone so unaffected areas can stay operational while cleanup proceeds.
Mold in ceiling tiles or wall cavities often points to HVAC condensate problems, skipping duct inspection means the system recontaminates treated surfaces.
Ductwork is inspected for contamination before the HVAC system is returned to service, preventing recontamination after treated surfaces are cleared.
Scope of Work
From a single water-damaged office to a multi-zone warehouse, the scope is defined by what the moisture inspection finds.
Visual inspection combined with moisture readings and air or surface samples to define the full affected area before any work begins.
Polyethylene containment barriers and HEPA air scrubbers isolate the work zone and capture airborne spores during removal.
Unsalvageable drywall, ceiling tiles, and insulation are removed and disposed of properly under Louisiana licensing requirements.
Ductwork and air handling units are inspected for mold contamination and treated before the system is returned to service.
Antimicrobial solution is applied to treated surfaces, followed by commercial dehumidification and drying to reach target moisture levels.
Post-job surface sampling and written documentation confirm the moisture source was corrected and clearance standards were met.
Moisture and mold check in below-grade crawl spaces.
Mold assessment after roof leaks, pipe breaks, or flooding.
Pre-lease or due-diligence moisture and mold inspection.
Why Choose Us
Commercial properties carry compliance obligations and operational pressures that require a structured, documented approach from the first call.
No work is scheduled until an on-site moisture inspection confirms the affected area and the source of the problem.
Every contractor arranged holds the state mold cleanup license under R.S. 37:2181, so your documentation is legally defensible.
Containment setups are designed to isolate the work zone so unaffected areas of the building can stay open where layout allows.
The written scope details containment method, removal approach, and post-remediation clearance testing before any work begins.
Partners have handled mold resulting from roof leaks, pipe failures, and storm flooding across office, retail, and warehouse properties.
Surface sampling and written clearance records are provided at job close, useful for insurance claims, lease renewals, and due diligence.
The Process
01
Submit your enquiry and we arrange an on-site moisture inspection to map the affected area and identify the moisture source.
02
You receive a written scope covering containment setup, removal method, and post-remediation clearance testing before any work is booked.
03
Licensed partners carry out containment, removal, antimicrobial treatment, and drying, then close with surface sampling and written documentation.
Pricing Estimates
| Job | Typical cost |
|---|---|
| Small commercial area remediation | $2,500-$7,500 |
| Office suite remediation | $5,000-$15,000 |
| Large commercial remediation | $15,000-$50,000 |
Describe the mold or moisture problem and we’ll arrange an on-site inspection with a written scope before anything is booked.